I.MX 6

i.MX 6

The below article explains how to build and install the SECO Linux OS BSP, where BSP stands for Board Support Package, on the i.MX platform.
It also covers SECO special features like Embedded Controller ,CPLD(Complex Programmable logic device) and LPC (Low Pin count interface) On-board and how to use them.The below section describes how to customize the SECO BSP according to the user needs and it will helps you to reduce the development time.

i.MX6 SECO Boards

The below section find out the technical information about the supported SECO Q7-standard board like Q7-928,μQ7-962, μQ7-A75-J & Single board computer SBC-A62-J , SYS-A62-10 , SBC-984 & SBC-B08.

Board BSP 5.0 BSP 6.0 BSP 7.0
Q7-928 - Qseven® standard module with NXP i.MX 6 Processor * * *
μQ7-962 - μQseven® standard module with NXP i.MX 6 Processor * * *
μQ7-A75-J - μQseven® standard module with NXP i.MX 6 Processor * * *
SBC-A62-J - Single Board Computer with NXP i.MX 6 Processor * * *
SBC-984 - Single Board Computer with NXP i.MX 6 Processor *
SBC-B08 - Single Board Computer with NXP i.MX 6 Processor *
SYS-A62-10 -10.1” Panel PC with NXP i.MX 6 Processor *
SYS-B08-7 -7” LCD display Panel PC with NXP i.MX 6 Solox Processor *

*= indicate that the bsp is supported by the board.

i.MX6 BSP 5.0

In this section you find informations for developing BSP 5.0 with the Seco ARM boards:

BSP 5.0 Components List

Getting Started with BSP 5.0

Getting a Custom BSP 5.0

BSP Customization

Back-Up and Restore a BSP 5.0

Yocto Build Guidline

i.MX6 BSP 6.0

In this section you find informations for developing BSP 6.0 with the Seco ARM boards:

BSP 6.0 Components List

Getting Started with BSP 6.0

Getting a Custom BSP 6.0

BSP Customization

Yocto Build Guidline 2.0

i.MX6 BSP 7.0 (Deprecated)

In this section you find informations for developing BSP 7.0 with the Seco ARM boards:

Only Supported Modules, SBC-A62-J & ΜQ7-962 and Some features are not available in BSP7 of Rocko(2.4) Yocto Layer

BSP 7.0 Components List

Getting Started with BSP 7.0

Getting a Custom BSP 7.0

Yocto Build Guidline BSP7

Note: In this BSP7.0 of 4-9-88 version is not supported some machine features by default.

  • LVDS resolution management
  • Ad-hoc wireless Yocto meta-layer

These are present in BSP6.0 and Same will be available for BSP8.0(Work in progress).

i.MX6 BSP 8.0

In this section you find informations for developing BSP 8.0 with the Seco ARM boards:

BSP 6.0 Components List

Getting Started with BSP 8.0

Getting a Custom BSP 6.0

BSP Customization

Yocto Build Guidline BSP8

Carrier Boards

Seco i.MX 6 modules are supported from the carrier described at the following link: Qseven Carrier Boards